Salve ragazzi...
vi chiedo un aiuto importante!
Mi sono avvicinato ora al mondo Cisco perchè me lo hanno richiesto a lavoro.
Dovrei configurare 6 porte dello Switch CISCO SG300-20 in modalità IEE802.3ad per comunicare con un altro Switch e aumentare la banda da 100Mb a porta all'unione delle 6 e arrivare così a 600Mb.
Potreste aiutarmi?
IEE802.3ad su CISCO SG300-20
Moderatore: Federico.Lagni
- antomi
- Cisco fan
- Messaggi: 48
- Iscritto il: mer 20 mag , 2009 11:24 am
i passaggi sono:
creare il port-channel ed impostarlo come trunk
SW(config)# interface port-channel 1
SW(config)#switchport trunk encapsulation dot1q
SW(config)#switchport mode trunk
POi impostare le interfacce in trunk ed aggiungerle al channel-group es:
interface range FastEthernet2/0/1 -6
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 1 mode active
Questo lo devi fare su tutte e 2 gli switch.
Fammi sapere se hai dubbi.
creare il port-channel ed impostarlo come trunk
SW(config)# interface port-channel 1
SW(config)#switchport trunk encapsulation dot1q
SW(config)#switchport mode trunk
POi impostare le interfacce in trunk ed aggiungerle al channel-group es:
interface range FastEthernet2/0/1 -6
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 1 mode active
Questo lo devi fare su tutte e 2 gli switch.
Fammi sapere se hai dubbi.