La linea sembra OK.
Codice: Seleziona tutto
router-cisco-ufficio#sh controllers vdsl 0
Controller VDSL 0 is UP
Daemon Status: Up
XTU-R (DS) XTU-C (US)
Chip Vendor ID: 'BDCM' 'BDCM'
Chip Vendor Specific: 0x0000 0xA415
Chip Vendor Country: 0xB500 0xB500
Modem Vendor ID: 'CSCO' ' '
Modem Vendor Specific: 0x4602 0x0000
Modem Vendor Country: 0xB500 0x0000
Serial Number Near: ***********************
Serial Number Far:
Modem Version Near: 15.3(3)M
Modem Version Far: 0xa415
Modem Status: TC Sync (Showtime!)
DSL Config Mode: AUTO
Trained Mode: G.993.2 (VDSL2) Profile 17a
TC Mode: PTM
Selftest Result: 0x00
DELT configuration: disabled
DELT state: not running
Trellis: ON ON
SRA: disabled disabled
SRA count: 0 0
Bit swap: enabled enabled
Bit swap count: 0 0
Line Attenuation: 0.0 dB 0.0 dB
Signal Attenuation: 0.0 dB 0.0 dB
Noise Margin: 31.2 dB 30.1 dB
Attainable Rate: 107868 kbits/s 33475 kbits/s
Actual Power: 14.2 dBm -17.4 dBm
Per Band Status: D1 D2 D3 U0 U1 U2 U3
Line Attenuation(dB): 7.0 16.8 26.8 2.6 12.9 19.7 23.8
Signal Attenuation(dB): 7.0 16.8 26.8 N/A 12.1 N/A N/A
Noise Margin(dB): 31.3 31.3 31.0 N/A 30.1 N/A N/A
Total FECC: 0 2
Total ES: 0 0
Total SES: 0 0
Total LOSS: 0 0
Total UAS: 36 36
Total LPRS: 0 0
Total LOFS: 0 0
0
Full inits: 1
Failed full inits: 0
Short inits: 0
Failed short inits: 0
Firmware Source File Name (version)
-------- ------ -------------------
VDSL embedded VDSL_LINUX_DEV_01212008 (1)
Modem FW Version: 130205_1433-4.02L.03.A2pv6C035j.d23j
Modem PHY Version: A2pv6C035j.d23j
Vendor Version: Ap6v35j.23j 68
DS Channel1 DS Channel0 US Channel1 US Channel0
Speed (kbps): 0 31495 0 3144
SRA Previous Speed: 0 0 0 0
Previous Speed: 0 0 0 0
Reed-Solomon EC: 0 0 0 2
CRC Errors: 0 0 0 0
Header Errors: 0 0 0 0
Interleave (ms): 0.00 0.00 0.00 0.00
Actual INP: 2.01 56.00 4.00 56.00
Training Log : Stopped
Training Log Filename : flash:vdsllog.bin
Ho fatto la configurazione tipica che uso su ADSL, con pvc 8/35, encapsulation aal5snap, ecc... ...ma non navigo !
Qualcuno ha una conf pronta ??
Grazie